How To Repair a Hole in A Leather Jacket
It was observed that repairing a leather jacket’s hole can be a challenging task. Actually, it all depends on the procedure and the materials used during the repair process. In the following context, I will share four practical steps to repair your leather jacket’s hole. By following these steps, you can recover the originality of your favorite item.
1. Point out the Damage
You need to carefully assess the hole in your real leather jackets and determine its size. This assessment enables you to select an appropriate repair method and materials. Later on, by using a soft cloth, gently clean the area surrounding the hole to clean it. This initial step ensures a clean surface for the repair process, making it easy to work on.
Furthermore, if the hole has loose threads over the jacket, cautiously remove them with scissors. However, you must be attentive to the surrounding leather while removing it and be cautious not to cut into it.
To access the hole, it's best to open the lining material with a sharp knife. Then, carefully unpick the arm section known as the escape route. Once you have access, you can perfectly repair the hole and enhance the leather's originality.
2. Insert Sub-Patch Behind the Leather Jacket
This is a crucial stage while fixing real biker leather jackets, and here, you have to apply a patch to your leather jacket hole. First, place it on a proper surface to ensure appropriate control. Ensure the backing fabric is cut enough to give plenty of excess but not too much. The backing fabric must be rounded off, as corners can cause complications when inserted. Make sure you insert the backing fabric suede side up if using leather. This link will help you with fixing the leather jacket hole.
3. Apply Leather Adhesive
Turn to the exterior side of the leather, where you have patched the fabric. Using the dull end of the needle, gently open the edges of the hole and spread a drop of leather adhesive between the fabric and the torn edges of the leather jacket. Remove the excessive adhesive material and allow it to set for several hours before proceeding. Don’t use a hair dryer or any heat sources because they are too harsh for leather.
After that, you must gently press the edges of the hole together to seal them. You can use a toothpick or any other tool to push the edges. Carefully hold them in place for a few minutes to allow the adhesive to press the edges tightly and bond them.
While applying this process, if the hole has left a slight gap, you can use leather filler to fill this up. Also, you apply the leather paint and blend it with the surrounding leather.
4. Conditioning the Jacket
After applying the fixing procedure, your leather jacket will have some dirt. To remove this dirt, you need to use a leather conditioner for a repaired leather jacket. This leads you to restore moisture, flexibility, and a classic appearance of your leather jacket.